Drilling screw holes into the excess edge of the mold, so when casting there is a method of sealing shut.
Trimming down the excess fiberglass. This was one of the stages I did not find the easiest, the extreme amount of dust from the fiberglass had me concerned. Konrad was on hand to make sure ventilation was okay and sucking up as much dust as possible, when he saw me struggling he would step in after asking if I wanted to him. Most times I declined as I found the whole process really interesting, the more I learnt about it the more I wanted to physically do without help of the technicians even when it was stages that only when one of them could do it I would make sure to aask questions about the hows and whys.
No comments:
Post a Comment